Cisco TelePresence SX20 Quick Set

Administrator guide

Table of contents

Introduction

Web interface

Advanced settings

Appendices

 

16

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Placing a call

You can use the Call Control page of the web interface to initiate a call.

Note: Even if the web interface is used to initiate the call it is the video system (display, microphones and loudspeakers) that is used for the call; not the PC running the web interface.

Calling someone

Enter one or more characters in the address input field until the name you want to call appears in the dynamic search list or, enter the complete name or number. Then press Dial.

Press End all to disconnect the call.

Calling more than one

A point-to-point video call (a call involving two parties only) may be expanded to include more participants if your system supports the optional built-in MultiSite feature (up to four participants, yourself included). The call will then become a video conference.

When in a call, enter the name or number of the next participant in the address input field, and then press Dial.

Press End all to terminate the entire conference.

To disconnect just one of the participants, press the button for that participant.

Sharing contents

Select a Presentation Source from the drop down list, and press the Start Presentation button.

Normally a PC is used as presentation source, but other options may be available depending on your system setup.

To stop the content sharing, press the Stop Presentation button that becomes visible while sharing.

Address input field

Call Control

D14908.01 SX20 Administrator Guide (TC5.1) 2012 FEBRUARY © 2012 Cisco Systems, Inc. All rights reserved.

www.cisco.com