Cisco Systems N5KC5596TFA Modifying a Port Profile, Configure terminal Enters configuration mode

Configuring Layer 2 Interfaces

Port Profiles

This example shows how to add the interface commands to a port profile named ppEth configured for Ethernet interfaces:

switch# configure terminal switch(config)# port-profile ppEth switch(config-port-prof)# switchport mode trunk

switch(config-port-prof)# switchport trunk allowed vlan 300-400 switch(config-port-prof)# flowcontrol receive on switch(config-port-prof)# speed 10000 switch(config-port-prof)#

Modifying a Port Profile

You can modify a port profile in port-profile configuration mode.

You can remove commands from a port profile using the no form of the command. When you remove a command from the port profile, the corresponding command is removed from the interface that is attached to the port profile.

Procedure

	Command or Action	Purpose
Step 1	configure terminal	Enters configuration mode.
	Example:
	switch# configure terminal
	switch(config)#

Step 2	port-profile [type {ethernet interface-vlan
	port channel}] name

Example:

switch(config)# port-profile type ethernet test

switch(config-port-prof)#

Enters the port profile configuration mode for the specified port profile and allows you to add or remove configurations to the profile.

Step 3	exit	Exits the port profile configuration mode.
	Example:
	switch(config-port-prof)# exit
	switch(config)#
Step 4	show port-profile	(Optional)
		Displays the port profile configuration.
	Example:
	switch(config)# show port-profile name

Step 5 copy running-config startup-config

Example:

switch(config)# copy running-config startup-config

(Optional)

Copies the running configuration to the startup configuration.

	Cisco Nexus 5000 Series NX-OS Interfaces Configuration Guide, Release 5.2(1)N1(1)
20	78-26881-OL