Configuring Virtual Port Channels
Enabling vPC
This example shows how to check that the required configurations are compatible across all the vPC interfaces:
switch# show vpc consistency-parameters global
Legend:
Type 1 : vPC will be suspended in case of mismatch
Name | Type | Local Value | Peer Value |
QoS | 2 | ([], [], [], [], [], | ([], [], [], [], [], |
|
| []) | []) |
Network QoS (MTU) | 2 | (1538, 0, 0, 0, 0, 0) | (1538, 0, 0, 0, 0, 0) |
Network Qos (Pause) | 2 | (F, F, F, F, F, F) | (1538, 0, 0, 0, 0, 0) |
Input Queuing (Bandwidth) | 2 | (100, 0, 0, 0, 0, 0) | (100, 0, 0, 0, 0, 0) |
Input Queuing (Absolute | 2 | (F, F, F, F, F, F) | (100, 0, 0, 0, 0, 0) |
Priority) | 2 | (100, 0, 0, 0, 0, 0) | (100, 0, 0, 0, 0, 0) |
Output Queuing (Bandwidth) | |||
Output Queuing (Absolute | 2 | (F, F, F, F, F, F) | (100, 0, 0, 0, 0, 0) |
Priority) | 1 | ||
STP Mode | |||
STP Disabled | 1 | None | None |
STP MST Region Name | 1 | "" | "" |
STP MST Region Revision | 1 | 0 | 0 |
STP MST Region Instance to | 1 |
|
|
VLAN Mapping |
|
|
|
STP Loopguard | 1 | Disabled | Disabled |
STP Bridge Assurance | 1 | Enabled | Enabled |
STP Port Type, Edge | 1 | Normal, Disabled, | Normal, Disabled, |
BPDUFilter, Edge BPDUGuard | 1 | Disabled | Disabled |
STP MST Simulate PVST | Enabled | Enabled | |
Allowed VLANs | - | 1,624 | 1 |
Local suspended VLANs | - | 624 | - |
switch# |
|
|
|
This example shows how to check that the required configurations are compatible for an EtherChannel interface:
switch# show vpc consistency-parameters interface port-channel 20
Legend:
Type 1 : vPC will be suspended in case of mismatch
Name | Type | Local Value | Peer Value |
Fex id | 1 | 20 | 20 |
STP Port Type | 1 | Default | Default |
STP Port Guard | 1 | None | None |
STP MST Simulate PVST | 1 | Default | Default |
mode | 1 | on | on |
Speed | 1 | 10 Gb/s | 10 Gb/s |
Duplex | 1 | full | full |
Port Mode | 1 | ||
Shut Lan | 1 | No | No |
Allowed VLANs | - |
Enabling vPC Auto-Recovery
Procedure
| Command or Action | Purpose |
Step 1 | switch# configure terminal | Enters configuration mode. |
Step 2 | switch(config)# vpc domain | Enters |
|
| existing vPC domain. |
| Cisco Nexus 5000 Series |
86 |