Chapter
Getting Started Guide | 5 |
|
LAN LEDs (Front Panel)
Solid Green: The LAN link is up and running at 1000 link speed, but is currently idle.
Blinking Green: The LAN link is up and running at 1000 link speed and is currently active. The LED flickers off with activity.
Solid Yellow: The LAN link is up and running at 10/100 link speed, but is currently idle.
Blinking Yellow: The LAN link is up and running at 10/100 link speed and is currently active. The LED flickers off with activity.
Off: No LAN link is detected.
Hard Disk Drive LEDs (Front Panel)
The LEDs associated with each of the installed disk drives indicate
The various states of the green LED indicates the drive activity:
•Solid Green: The disk drive is configured but is currently idle.
•Flicker Green: The disk drive is configured, active, and not rebuilding. Flickers off with activity.
•Blinking Green: The disk drive is configured and a RAID array is currently rebuilding to the disk drive.
•Off: The disk drive is not configured (not part of a RAID or JBOD array and not exported). The various states of the red LED indicate that the disk drive is in an error condition:
•Solid Red: The disk drive is in a failed state.
•Blinking Red: The disk drive is predicated to fail (via S.M.A.R.T.). We recommend that you replace the disk drive to avoid the loss of data.
•Off: The drive is OK.
The various states of the white LED indicate that there is a locate request currently on the disk drive:
•Blinking White: There is a locate request currently on the disk drive (from the Storage Status page on the configuration interface).
NOTE: There can only be one locate request set for a disk drive at one time.
• Off: The disk drive is not marked by a locate request.
Chapter 5: LEDs | 51 |
