Cisco Systems PA-4C-E 1 manual Using the show version or show hardware Commands

Configuring the HP ESCON PA

Step 3 Specify one of the new interfaces with the show interfaces port adapter type slot/interface command and verify that the first line of the display specifies the interface with the correct slot number. Also verify that the interface and line protocol are in the correct state: up or down.

Step 4 Display the protocols configured for the entire system and specific interfaces with the show protocols command. If necessary, return to configuration mode to add or remove protocol routing on the system or specific interfaces.

Step 5 Display the running configuration file with the show running-configcommand. Display the configuration stored in nonvolatile RAM (NVRAM) using the show startup-configcommand. Verify that the configuration is accurate for the system and each interface.

If the interface is down and you configured it as up, or if the displays indicate that the hardware is not functioning properly, ensure that the network interface is properly connected and terminated. If you still have problems bringing up the interface, contact a service representative for assistance.

This section includes the following subsections:

•Using the show version or show hardware Commands, page 29

•Using the show controllers Commands, page 30

•Using the show diag Command, page 31

•Using the show interfaces Commands, page 31

Using the show version or show hardware Commands

Display the configuration of the router hardware, the software version, the names and sources of configuration files, and the boot images using the show version (or show hardware) command.

Note	The outputs that appear in this document may not match the output you receive when running these
	commands. The outputs in this document are examples only.
	Cisco 7200 Series and Cisco 7200 VXR Series Routers—Example Output of the show version Command
	Following is an example of the show version command from a Cisco 7200 series router:
	Router# show version
	Cisco Internetwork Operating System Software
	IOS (tm) 7200 Software (C7200-IS56I-M), Released Version 12.1
	Copyright (c) 1986-2000 by cisco Systems, Inc.
	Compiled Thu 27-Jul-00 13:22 by biff
	Image text-base: 0x60008960, data-base: 0x613C4000
	ROM: System Bootstrap, Version 12.1 RELEASE SOFTWARE (f)
	BOOTFLASH: 7200 Software (C7200-BOOT-M), Version 12.1, RELEASE SOFTWARE R
	router uptime is 5 hours, 6 minutes
	System returned to ROM by reload at 04:35:10 UTC Thu Aug 10 2000
	System image file is "tftp://181.23.250.2/jdoe/c7200-is56i-mz.121-5.T"
	cisco 7206VXR (NPE300) processor (revision B) with 122880K/40960K bytes of memo.
	Processor board ID 15463825
	R7000 CPU at 262Mhz, Implementation 39, Rev 1.0, 256KB L2, 2048KB L3 Cache
	6 slot VXR midplane, Version 2.0
	Last reset from power-on
	Bridging software.
	PA-4C-E 1-Port High-Performance ESCON Channel Port Adapter Installation and Configuration
OL-3743-02		29