Removing and Installing Port Adapters
Cisco 7200 Series Routers and Cisco 7200 VXR
Step 1
To remove the port adapter, place the port adapter lever in the unlocked position. (See A.) The port adapter lever remains in the unlocked position.
Step 2
Grasp the handle of the port adapter and pull the port adapter from the router, about halfway out of its slot. If you are removing a blank port adapter, pull the blank port adapter completely out of the chassis slot.
Step 3
With the port adapter halfway out of the slot, disconnect all cables from the port adapter. After disconnecting the cables, pull the port adapter from its chassis slot.
Step 4
To insert the port adapter, carefully align the port adapter carrier between the upper and the lower edges of the port adapter slot. (See B.)
Step 5
Carefully slide the new port adapter halfway into the port adapter slot. (See B.)
Step 6
With the port adapter halfway into the slot, connect all required cables to the port adapter. After connecting all required cables, carefully slide the port adapter all the way into the slot until the port adapter is seated in the router midplane.
Step 7
After the port adapter is properly seated, lock the port adapter lever. (See A.)
Port adapter lever (locked position)
|
| 6 |
| 5 |
|
|
| FAST ETHERNET |
|
| ETHERNET 10BT |
A |
| 4 |
3 |
| |
| 0 | |
| FAST SERIAL | |
|
| 2 |
| 1 |
|
| Cisco 7200 | FAST ETHERNET INPUT/OUTPUT CONTROLLER |
|
| |
| Series | 0 |
Note: This adapter | Port adapter lever | |
removal applies to any | ||
port or service adapter. | (unlocked position) | |
Slot |
| TOKEN RING |
| 6 | |
guide | 5 |
|
3 | 4 | |
|
| FAST ETHERNET |
|
| ETHERNET 10BT |
|
| 0 |
| 1 |
|
| Cisco 7200 |
|
| Series | 27996 |
| B | |
|
|
24 |
| |
|
