Cisco Systems PA-4C-E 1 manual Routerconfig# microcode ecpa slot0xcpa28-1

Configuring the HP ESCON PA

18	.. unknown	BC7BEC5D	51EB90	17	246184	Sep 18 2000 06:46:56 xcpa218-6_seg_802
19	.. unknown	C09633A6	5A8284	18	562804	Sep 18 2000 06:47:09 xcpa218-6_seg_cmpc
20	.. unknown	0B58D705	5BFBEC	18	96488	Sep 18 2000 06:47:37 xcpa218-6_seg_csna
21	.. unknown	29DEAA84	630414	17	460712	Sep 18 2000 06:47:42 xcpa218-6_seg_eca
22	.. unknown	95CADB93	646BDC	21	91976	Sep 18 2000 06:48:05 xcpa218-6_seg_offload
23	.. unknown	82F8A3D6	657948	17	68844	Sep 18 2000 06:48:10 xcpa218-6_seg_pca
24	.. unknown	7EECB670	65B64C	18	15492	Sep 18	2000	06:48:13 xcpa218-6_seg_push
25	.. unknown	B4A58886	72583C	18	827760	Sep 18	2000	06:48:14 xcpa218-6_seg_sslc
26	.. unknown	73CB2859	74CE68	19	161196	Sep 18	2000	06:48:56 xcpa218-6_seg_tcpip
27	.. unknown	0989F473	7F31C8	20	680672	Sep 18	2000	06:49:04 xcpa218-6_seg_tn3270

12373560 bytes available (8204744 bytes used)

To configure the microcode for an HP ESCON PA on a router configured with Cisco IOS

Release 12.1(5)T or later:

Step 1 Enter the privileged EXEC configuration mode using the enable command:

Router> enable

Password:

Router#

Note For complete information on the privileged EXEC configuration mode, refer to the “Using the EXEC Command Interpreter” section on page 26 .

Step 2 If you need to copy a new HP ESCON PA microcode image to your router’s Flash memory, refer to the “Using Flash Memory” section on page 36 , then proceed to Step 3.

Step 3 In privileged EXEC configuration mode, enter global configuration mode and specify that the console terminal will be the source of the configuration subcommands:

Router# configure terminal

To load the microcode from an individual microcode image that is stored as a file on a Flash memory card, enter the microcode command, the processor type, the specific memory location of the HP ESCON PA microcode image, and the exact argument for filename (xcpa28-1is used in this example):

Router(config)# microcode ecpa slot0:xcpa28-1

Router(config)# microcode reload

Note The microcode reload command is written automatically in the configuration file following the microcode ecpa command when you modify the system default to load a microcode image.

The no microcode command cancels any existing instructions to load an image from a Flash memory card and restores the default configuration:

Router(config)# no microcode ecpa slot0:xcpa28-1

Step 4 To save the configuration file, press Ctrl-Z(or type end), then copy the new configuration to NVRAM:

Router# copy running-config startup-config

PA-4C-E 1-Port High-Performance ESCON Channel Port Adapter Installation and Configuration

OL-3743-02 35