Cisco Systems PA-4R manual Using the ping Command

VIP2 and the 4R Port Adapter

Physical slot 8, ~physical slot 0x7, logical slot 8, CBus 0

Microcode Status 0x4

Master Enable, LED,					WCS	Loaded
Board is analyzed
Pending I/O Status: None
EEPROM format			version 1
VIP2 controller, HW					rev	2.2, board revision UNKNOWN
Serial number: 03341418						Part number:				73-1684-02
Test history:			0x00			RMA number:				00-00-00
Flags: cisco 7000 board; 7500 compatible
EEPROM contents (hex):
0x20: 01 15			02 02		00 32 FC 6A 49 06					94	02 00		00 00 00
0x30:	07	2B	00	2A	1A	00 00	00	00	00	00	00	00	00 00	00

Slot database information:

Flags: 0x4 Insertion time: 0x3188 (01:20:53 ago)

Controller Memory Size: 8 MBytes

PA Bay 0 Information:

Token Ring PA, 4 ports

EEPROM format version 1

HW rev 1.1, Board revision 0

Serial number: 02827613 Part number: 73-1390-04

PA Bay 1 Information:

Token Ring PA, 4 ports

EEPROM format version 1

HW rev 1.1, Board revision 88

Serial number: 02023786 Part number: 73-1390-04

Using the ping Command

The ping command allows you to verify that an interface port is functioning properly and to check the path between a specific port and connected devices at various locations on the network. This section provides brief descriptions of the ping command. After you verify that the system and VIP2 have booted successfully and are operational, you can use this command to verify the status of interface ports.

The ping command sends an echo request out to a remote device at an IP address that you specify. After sending a series of signals, the command waits a specified time for the remote device to echo the signals. Each returned signal is displayed as an exclamation point (!) on the console terminal; each signal that is not returned before the specified time-out is displayed as a period (.). A series of exclamation points (!!!!!) indicates a good connection; a series of periods (.....) or the messages [timed out] or [failed]

indicate that the connection failed.

Following is an example of a successful ping command to a remote server with the address 1.1.1.10:

Router# ping 1.1.1.10 <Return> Type escape sequence to abort.

Sending 5, 100-byte ICMP Echoes to 1.1.1.10, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/15/64 ms Router#

If the connection fails, verify that you have the correct IP address for the server and that the server is active (powered on), and repeat the ping command.

For complete descriptions of interface subcommands and the configuration options available for VIP2-related interfaces, and which support VIP2 functionality, refer to the publications listed in the section “If You Need More Information” on page 2.

PA-4R Half-Duplex Token Ring Port Adapter Installation and Configuration

26 OL-3589-01