VIP2 and the 4R Port Adapter
Figure 10 Pulling a Port Adapter Out of a Slot (Partial Port Adapter View)
H3149
Step 7 If you removed a port adapter, place it in an antistatic container for safe storage or shipment back to the factory. If you removed a blank port adapter, no special handling is required; however, store the blank port adapter for potential future use.
Step 8 Remove the new port adapter from its antistatic container and position it at the opening of the slot. (See Figure 11.)
Step 9 Carefully align the port adapter carrier between the upper and lower edges of the port adapter slot, as shown in Figure 11.
Figure 11 Aligning a Port Adapter in a Port Adapter Slot
H3150
Carrier
Upper edge
Lower edge
Caution To prevent jamming the carrier between the upper and lower edges of the port adapter slot and to ensure that the edge connector at the rear of the port adapter seats in the connector at the rear of the port adapter slot, make certain that the leading edges of the carrier are between the upper and lower slot edges, as shown in the cutaway in Figure 11.
16 |
| |
|
