3-53
Cisco SFS 7024 Hardware Users Guide
OL-8794-02
Chapter
Note The combination of the Transport Domain and the Transport Address determines the trap destination.
• Port
Specifies the TCP port which the SNMP trap will be sent.
• Timeout
Specifies the time that the trap sender waits on a response before re-sending the trap.
• Retry Count
Specifies the number of attempts to be made to send the trap after a timeout condition occurs.
Note Timeout and Retry Count are SNMP v2.c and above. Not applicable for v1 traps.
• Tag Li st
Specifies which traps should be sent to this particular destination.
Note RFC2233 specifies the link up/down traps. Including RFC2233 in the Tag List specifies that the trap
receiver will get link up/down traps.
• Parameters
Specifies a mapping to an entry in the SNMP Target Parameters table, determining the version of
SNMP to use.
• Storage Type
This field determines whether or not the entry is saved for each reboot of the SFS 7024.
–
Nonvolatile means that the value is saved, and remains with each subsequent reboot.
–
Volatile or Other indicates it will not be saved.
• Status
Indicates the current status of the row. The row may be in one of three states:
–
Active
–
Not in service
–
Not Ready
Note A status of not in service indicates that the current row will not be used in the event a trap is generated
by the system. Toggling a trap to not in service, which temporarily suspends trap forwarding, may be
useful to keep values intact.
SNMP Target Parameters:
• Parameter Name
Specifies a mapping to an entry in the SNMP Target Parameters table, determining the version of
SNMP to use.
• MP Model
The Message Processing Model to be used when generating SNMP messages for entry.