2-18
Cisco SFS 7024 Hardware Users Guide
OL-8794-02
Chapter
Figure 2-5 SFS 7024 Chassis — Leaf Module Slot Numbering
Step 2 To install a module or filler, hold it so that the ejector handles are on the bottom.
Step 3 Pull the handles out to extend them. Slide the module into the appropriate slot of the chassis until it
makes contact with the backplane. As the module seats in the chassis, the handles will begin to close.
Step 4 Push the handles in to fully close.
Note Be sure that all cards are fully inserted in their respective chassis slots, and that the handles are in the
locked position. This prevents accidental removal, provides proper grounding for the system, and helps
to seat the bus connectors in the backplane receptacles.
Removing a Module or Blank
The handles are self-locking. To unlock, push up on the handles to disengage from the lock notch. Then
gently pull the handles out and slide the module out of the slot.
Note If removing, but not replacing a module, remember to replace with a module blank. All slots must be
either populated with a module or have blanks for EMI and thermal integrity.
Leaf 1 Leaf 2
Leaf 4
Leaf 6
Leaf 8
Leaf 10
Leaf 12
Leaf 3
Leaf 5
Leaf 7
Leaf 9
Leaf 11
Leaf 13
Leaf 15
Leaf 17
Leaf 19
Leaf 21
Leaf 23
Leaf 14
Leaf 16
Leaf 18
Leaf 20
Leaf 22
Leaf 24