REVIEW DRAFT—CISCO CONFIDENTIAL
A-23
Cisco XR 12416 Router Chassis Installation Guide
OL-xxxxx-xx
Appendix A Repackaging the Router
Repackaging the Routers
Completing the Repackaging
To repackage the router, use Figure A-1 on page A-4 as a reference and follow
these steps:
Step 1 Verify that the anchor clips fastening the chassis to the scissor-jack platform are
installed correctly and that the bolts are tight.
Step 2 Verify that the bolts fastening the hold-down brackets to the sides of the
scissor-jack platform and the top of the pallet are tight.
Step 3 Pull the plastic bag over the router to protect it against electrostatic discharge
(ESD) and dust.
Step 4 Place the side of the accessories package with the single box containing the
center-mount rack-mounting brackets against the back panel of the router on the
extended deck of the pallet body.
Step 5 Place the folded corrugated spacer on top of the accessories package, then place
the two foam inserts around the top of the router.
Step 6 To install the U-shaped, corrugated side panels, use Figure A-1 on page A-4 as a
reference and follow these steps:
a. Set the long side of one panel on the pallet base such that it sits inside the
bead-boards attached to the outside corners of the pallet riser blocks and
against the side of the pallet platform.
b. Set the narrow end flaps of the panel inside the bead-boards attached to the
outside corners of the pallet riser blocks.
c. Position the opposite U-shaped side panel such that one narrow end flap is
inside the narrow end flap of the first U-shaped side panel, while the other
narrow end flap is outside the narrow end flap of the first U-shaped side panel.
Note Because the two U-shaped side panels are identical, interlocking them in
this fashion maintains the correct overall container dimensions and
strength.