English
Press the LOAD/PARK key on the front panel to load the paper in to the printer. The paper will stop at the first line of printing, or “top of form”.
Insert the top cover again and raise it to the upright position.
This is done by inserting the side pins of the top cover into the slots in the upper case.
Slide the paper support upwards until it stops to provide additional guidance and separation of the inbound and outbound paper.
If the ON LINE indicator light is not lit, press the ON LINE key to ensure the printer is ready to print.
Fanfold Paper (Bottom Tractor Mode)
Turn the power off to the printer. Adjust the head gap lever for the thickness of paper that you are using, then set the paper feed selector to the bottom tractor mode position.
While lifting up the printer on its back edge, pull out the paper stand shafts (1) and lock them in the forward position.
The pull tractors are shown in (2)
Unlock the pull tractors by pushing the tractor clamping le- vers (1) upwards.
Slide the tractors (2) to approximate width of paper. The plastic rib (3) moulded in to the lower case will give you an indication of the
14
