Setting Acoustic Features (ADJUST MODE)

Selecting adjust mode settings

Adjust the settings to suit your sound system.

1.Press the [ADJUST] button to enter the AD-

JUST MODE.

2.Press the [] or [] [DISP] button to select item to set.

Each time the [] or [] [DISP] button is pressed, the indications change as shown below.

Adjust the contrast

(CONTRAST)

Set speaker to on or off

(SP-SEL )

Set speaker filter frequency

(FILTER )

Adjust speaker output level

(SP-GAIN )

Set speaker delay time

(DELAY )

Set Dolby digital

(Dolby D )

Set Dolby Pro Logic II

(PL II CNT )

This function is only available Dolby PL II’s music mode selected in Dolby D function.

Set parametric equalizer

(P.EQ )

Adjust the RCA input sensitivity

(RCA SENS)

Press the [ADJUST] button to return to the

original mode.

3.When an is displayed at the end of a set- ting, press the [ENT] button to enter the ad- just mode.

When no appears at the end of a menu item, the display will return to the setting contents after two seconds.

4.Press the [] or [] [VOL] button to adjust the value.

5.Press the [ADJUST] button to return to the original mode.

Adjusting contrast (CONTRAST)

This function is used to adjust display contrast.

The initial value is [CNTRST.4].

1.Press the [ADJUST] button to enter the AD-

JUST MODE.

2.Press the [] or [] [DISP] button to show the [CONTRAST] display.

3.Press the [] or [] [VOL] button to adjust the contrast from [CNTRST.1] to [CNTRST.7].

4.Press the [ADJUST] button to return to the original mode.

The adjustment range is [CNTRST.1] to [CNTRST.7].

Turning speakers on or off (SP-SEL)

The center speaker, rear (surround) speakers and sub woofer have to be set to on or off to achieve maximum sound quality.

The initial setting is [ON].

1.Press the [ADJUST] button to enter the AD-

JUST MODE.

2.Press the [] or [] [DISP] button to change to the [SP-SEL] display.

3.Press the [ENT] button to display the adjust- ment item.

Press the [] or [] [DISP] button to select [CTR-SP], [SRD-SP] or [SUB-W].

CTR-SP: center speaker

SRD-SP: rear (surround) speaker

SUB-W: subwoofer

4.Press the [] or [] [VOL] button to select [ON] or [OFF].

ON: Speaker installed

OFF: Speaker not installed

When a sub woofer is used, set [ON+], [ON-] or [OFF]. The normal setting is [ON+], but use the [ON-] setting when this provides a better effect for low frequency range.

DVC920 9

280-7804-00_09-18(En)

9

2/22/02, 2:06 PM

280-7804-00

Page 5
Image 5
Clarion DVC920 manual Setting Acoustic Features Adjust Mode, Selecting adjust mode settings, Adjusting contrast Contrast