Jumper and Switch Settings

Jumper Selections

Cancel Auto Rearm. Disables the Automatic Rearm Feature.

On = Auto Rearm Disabled

Off = Auto Rearm Enabled

Parking Light Polarity. Selects the polarity (+/-) for the output of the on-board Parking Light relay.

Pin 1 + Pin 2 = positive

Pin 2 + Pin 3 = negative

Dome Light Polarity. Selects the polarity (+/-) for the output of the on-board Illuminated Entry/Exit relay.

Pin 1 + Pin 2 = positive

Pin 2 + Pin 3 = negative

Auxiliary Function 1 Polarity. Selects the polarity (+/-) for the output of the on-board Auxiliary Function 1 relay.

Pin 1 + Pin 2 = positive

Pin 2 + Pin 3 = negative

Programming Switches

1.Door Lock Pulse Width. Selects between a 1-second and a 4-second output for door locking and unlocking. Set to 4 seconds when interfacing into vehicles equipped with vacuum door locking systems.

2.Passive Locking. When the switch is on, the system will automatically lock the doors with Auto Rearm and Passive Arming.

3.Ignore Delayed Domelight. For use with vehicles equipped with a timed dome light circuit that stays on after door has been closed. When the switch is on, the system will ignore the dome light circuit during arming to prevent the system from responding with an open zone indication each time the system is armed.

4.Horn Honk / Arming Output. Selects between pulsed or constant output for the Orange/blue wire.

5.Comfort Closure. Sets the system to provide a 40 second output on the door lock wire (White/green (-) or White/blue (+12v)) when the system is Armed to activate the Comfort Closure feature found on many late model European vehicles. Vehicles equipped with this feature will normally close the windows and sunroof automatically when the door key is held to the lock position.

6.Remote Space Shield III Adjustment. Enables remote sensitivity adjustment of the Space Shield III (included with the MS8300) when connected to the 4-pin Optional Sensor harness.

Page 12 - MS8200 / MS8300 Installation Manual