1.Turn on the ignition.
2.Press and hold the Override switch.
•The status LED will turn on red.
3.Within 5 seconds:
Continue holding the Override switch and Press Transmitter Button 1*
For remote arming with chirp confirmation.
Release the Override switch and Press Transmitter Button 1*
For remote arming without chirp confirmation.
•The status LED will flash once quickly to confirm that the new Remote Transmitter has been added.
4.Turn off the ignition.
Deleting Transmitters (Adding a Remote Transmitter and Erasing All Other Remote Transmitters From the System)
1.Turn on the ignition.
2.Press and hold the Override switch.
•The status LED will turn on red.
Continue to hold the override switch.
•After 5 seconds, the status LED will flash 4 times, then turn on red again.
3.Within 5 seconds:
Continue holding the Override switch and Press Transmitter Button 1*
For remote arming with chirp confirmation.
Release the Override switch and Press Transmitter Button 1*
For remote arming without chirp confirmation.
•The status LED will flash once quickly to confirm that the new Remote Transmitter has been added.
4.Turn off the ignition.
*The Button that is pressed will be the Arm/Disarm Button on that Remote Transmitter. You may program any of the Transmitter’s buttons to arm and disarm the system at this point.
Page 16 - MS8200 / MS8300 Installation Manual