When latched or timed operation is selected, the output will reset (turn off) each time the system is armed or disarmed.

Pin 15 - ORANGE/blue: Alarming / Horn Honk (-) output

Provides a negative output when the system is triggered to activate a relay. The output is selectable for continuous or pulsed operation. See Programming Switches.

This wire can be connected to a relay to honk the vehicle’s horn, or activate an auxiliary siren or air horns when the system is triggered.

Pin 16 - BLACK/white: Dome Light (+/-) output [on-board relay]

Illuminated Entry/Exit output. Provides a selectable positive (+12v) or negative (-) output to turn on the vehicle’s dome light when the system is disarmed and when the ignition key is turned off. Normally, this wire can be connected directly to the door switch circuit. Be sure to set the polarity of this output. See Jumper and Switch Settings.

Pin 17 - BLUE/red: Starter Defeat Normally Open (-) output

Provides a negative output while the system is Disarmed to enable the starter circuits. Connect to the provided Starter Kill Relay socket as shown.

 

to Starter

 

Solenoid

to alarm

BLUE

BLUE/red wire

 

 

BLACK

to alarm

 

VIOLET wire

cut

 

 

RED

VIOLET

to Ignition Key +12v in “on” and “start”

In this configuration, the vehicle will only start when the system is both connected and disarmed.

Pin 18 - RED/white: Secondary Power (+12v) input [20A fuse]

Connect to a fused +12v source. This wire is the source of power for all of the system’s onboard relays, so a source of power capable of maintaining the necessary current is essential. Be sure to install a fuse near the connection. Do not remove or bypass the fuse holder included on the wire harness.

Page 10 - MS8200 / MS8300 Installation Manual