8. OPERATIONS
Basic Operations | Note: Be sure to read this chapter referring to the front diagrams of |
chapter “3. CONTROLS” on page 5 (unfold). |
CAUTION
When the unit is turned on, starting and stopping the engine with its volume raised to the maximum level may harm your hearings. Be careful about adjusting the volume.
Note:
•Use this unit after starting the engine.
Adjusting the volume
Operate the VOLUME button 2 in the direction of the arrows w (up) or z (down) to adjust the volume;
w: Increases the volume.
z: Decreases the volume.
∗The volume level indicated in the display is in a range from 0 (minimum) to 33 (maximum).
English
s’Owner manual
Turning on and off the power
Note:
•Be careful about using this unit for a long time without running the engine. If you drain the car’s battery too far, you may not be able to start the engine and this can reduce the service life of the battery.
1.Press the POWER button 1.
2.The illumination and display on the unit light up. The unit automatically remembers its last operation mode and will automatically switch to display that mode.
3.Press and hold the POWER button 1 for 1 second or longer to turn off the power for the unit.
Note:
•About the “SYSTEM CHECK”
The confirmation of connected equipment must be performed for this unit only when the wiring connection is complete and power is turned on to the unit first. When the power is supplied, “SYSTEM ” and “PUSH PWR” appear alternately in the display. Press the POWER button 1, the system check starts inside the unit. When “COMPLETE” appears, press once again the POWER button 1.
Selecting a mode
1.Press the FNC button 1 to change the mode of operation.
2.Each time you press the FNC button 1, the mode of operation changes in the following order:
Radio mode ➜ DAB mode ➜ CD changer mode ➜ DVD changer mode ➜ TV mode ➜ Radio mode...
∗External equipment not connected with CeNET is not selected.
CAUTION
While driving, keep the volume at a level at which external sounds can be heard.
Switching the display
When the panel is closed:
Press the DISP button @ to select the desired display.
Each time you press the DISP button @, the display switches in the following order:
Notes:
•Once selected, the preferred display becomes the default display. When a function adjustment such as volume is made, the display momentarily switches to that function’s display, then returns back to the preferred display several seconds after the adjustment.
VRX653R 15