Clarion VRX653R 6.REMOVING THE MAIN UNIT, 7.CAUTIONS ON WIRING

6. REMOVING THE MAIN UNIT

1.When the rear of the main unit has been secured with the method shown in Figure 6 unfasten the special screw.

2.Remove the outer escutcheon.

3.Insert the hook plate between the spring and the universal mounting bracket, fit tab

Bof the spring into hole A of the hook plate, then pull the main unit out by the hook plate. (Insert both the right and left edges of the hook plate.) (Figure 9)

Note: Keep the hook plate. You cannot remove the main unit without disengaging the hook plate.

English connectionmanual Installationand Wire

7. CAUTIONS ON WIRING

1.Be sure to turn the power off before wiring.

2.Be particularly careful where you route the wires.

Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.

3.If the fuse should blow, check to see if the wiring is correct.

If it is, replace the fuse with a new one with the same amperage rating as the original.

4.When any fuse is to be replaced, pull out the fuse (15A) at the rear of the main unit and put in a new one (Fig.10).

Figure 10

CAUTION

After the connection, fix the lead by a clamp or insulation tape for protection.

VRX653R 49