9. IN CASE OF DIFFICULTY

 

Problem

Cause

Measure

 

Power does not

Fuse is blown.

Replace with a fuse of the same amperage. If the

 

turn on.

 

fuse blows again, consult your store of purchase.

 

(No sound is

 

 

 

 

 

 

 

 

Consult your store of purchase.

 

produced.)

Incorrect wiring.

 

 

 

 

 

 

 

 

 

 

Nothing happens

The microprocessor has

Turn off the power, then press the RELEASE lever

 

when buttons are

malfunctioned due to noise,

6 and remove the DCP.

 

pressed.

etc.

Press the RESET button for about 2 seconds with

 

 

 

 

a thin rod.

 

Display is not

 

 

 

 

 

 

 

accurate.

 

 

 

 

 

 

GENERAL

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

DCP or main unit connectors

Wipe the dirt off with a soft cloth moistened with

 

 

 

are dirty.

cleaning alcohol.

 

 

 

 

 

 

 

 

 

 

The remote

The display is not open.

The remote controller does not work unless the

 

controller does

 

display is open.

 

not work.

 

 

 

 

 

 

 

 

 

Direct rays of the sun fall on

When direct rays of the sun fall on the light-

 

 

 

 

 

 

the light-receptive part of the

receptive part of the remote controller, it may not

 

 

 

remote controller.

work.

 

 

 

 

 

 

 

 

 

 

 

 

The batteries of the remote

Check the batteries of the remote controller unit.

 

 

 

controller unit are dead or

 

 

 

 

 

 

 

 

there is no battery in the

 

 

 

 

 

 

 

 

remote controller unit.

 

 

 

 

 

 

 

 

 

 

The image is not

The parking brake is not

Check that the parking brake is applied.

 

displayed.

pulled.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The display is

The brightness control is too

Adjust the brightness properly.

 

dark.

low.

 

 

 

 

 

 

 

 

 

 

 

 

 

The operating condition is

The temperature inside the vehicle may be 0˚C or

 

 

 

not good.

less. Set to an appropriate temperature (25˚C or

 

 

 

 

so) and check it again.

 

 

 

 

 

 

 

 

 

 

 

 

The headlight of the vehicle

The display is made dark at night to prevent the

TV

 

 

is lit.

glare (When the headlight of the vehicle is lit in the

 

 

 

daytime, the display gets dark).

 

 

 

 

 

 

 

 

 

The color of the

The color is not adjusted

Check that COL and HUE are adjusted properly.

 

display is light or

adequately.

 

 

 

 

 

 

a shade of color

 

 

 

 

 

 

 

is not good.

 

 

 

 

 

 

 

 

 

 

 

When the VTR is

Improper NTSC/PAL setting

Set the NTSC/PAL properly according to the VTR.

 

connected, the

 

 

 

 

 

 

 

image is

 

 

 

 

 

 

 

disturbed.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

English

s’Owner manual

VRX653R 41