ClearSounds CSC600D manual Using your Speakerphone, Answering a Call, Using the Handset

hearing aid “T-switch” to the “T” position. Make sure to hold the handset close to your T-coil.

█Using your Speakerphone

For optimal speakerphone performance, avoid the following:

•Areas with high background noise (The microphone might pick up these sounds and prevent the speakerphone from going into the receiving mode when you finish talking).

•Surfaces affected by vibration.

•Recessed areas such as in a corner, under a cupboard, or next to a cabinet, which can generate an echo effect.

To answer or place a call using the speakerphone, press the Speaker key on the base.

█Answering a Call

NOTE: Make sure the ringer switch is set to HI, MED or LO, or the phone will not ring. If you have selected the strobe to be ON, it will flash on all settings.

Using the Handset

1.To answer a call, lift the handset and speak.

2.Adjust your volume and tone settings if needed.

3.To end the call, replace the handset on the base.

Using the Speakerphone

1.To answer a call, press the Speaker key on the base.

2.Adjust your volume by using the volume control VOLUME- or VOLUME+ located on right side of the phone.

3.To end the call, press the Speaker key again on the base.

Using a Headset or Neckloop (see page 21)

19 – ENGLISH