Removal and replacement procedures

Remove the system board:

1.Disconnect the fan cable 1 from the system board.

2.Remove the Phillips PM2.5×4.0 screw 2 that secures the system board to the base enclosure.

3.Remove the two Phillips PM2.5×4.0 screws 3 that secure the optical drive connector board to the base enclosure.

4.Release the RJ-11 connector 1 from the clip built into the base enclosure.

5.Flex the left side of the base enclosure 2 until the external monitor connector 3 is clear of the opening of the base enclosure.

6.Lift the rear edge of the system board 4 until it rests at an angle.

7.Remove the system board 5 by sliding it back.

4–36

Maintenance and Service Guide

Page 79
Image 79
Compaq 615 manual Removal and replacement procedures