Removal and replacement procedures

3.Turn the computer right-side up with the front toward you.

4.Remove the two Phillips PM2.5×6.0 screws 1 and the Phillips PM2.0×4.0 screw 2 that secure the top cover to the base enclosure.

5.Lift the rear edge 1 of the top cover until it rests at an angle.

6.Slide the top cover 2 back at an angle until the TouchPad cable 3 is accessible.

7.Disconnect the TouchPad cable from the system board.

8.Remove the top cover 4 by lifting it straight up.

Reverse this procedure to install the top cover.

Maintenance and Service Guide

4–33

Page 76
Image 76
Compaq 615 manual Removal and replacement procedures