Compaq MTEK6000 user manual Configuration Mode, Editing Parameters

MTEK6000 SERIES USER'S MANUAL

Configuration Mode

Configuration mode allows you to set-up the MTEK6000's initial configuration; change any of the operating parameter values, and set alarm conditions and limits. MTEKManager version 1.x or the optional external keypad and display are required to

perform configuration. See the MTEKManager on-line help for operating instructions. MTEKManager version 1.x is supplied, upon request, with your unit consisting of Virtual Keypad and other utilities.

Virtual Keypad or Optional External Keypad and Display Operation

To access any operating mode:

1.Wake-up the device.

2.Press the keypad key that corresponds to the mode you want (Fig. 3-1).

conf for configuration mode

alrm for alarm mode

cal for calibration mode esc to go back to display mode

While in Display Mode, pressing the ↑ and

↓keys allow you to scroll through the parameter labels. You may use the jump key to directly view any of the assigned labels; press jump, then enter the label number, followed by pressing ent. You can use the function keys (F0 - F9) to view previously assigned parameters. (software lets you assign function keys and labels to any parameter.) To enter configuration mode, press conf. If configuration mode is password protected, the MTEK6000 will display ENTER PASSWORD?. Only a valid password entry would then be given access to this mode.

Configuration mode allows you to set-up the device's initial configuration, change any of the operating parameter values, set alarm conditions and limits, or assign function keys to a parameter. While in the configuration mode, the device continues to operate normally; it continues to collect pulses, sample live pressure and temperature values, calculate corrected volume, and collect historical data.

Editing Parameters

1.Enter configuration mode by pressing conf (use the password if required).

2.Display the desired parameter: press jump followed by the address of the parameter, then press ent (see Appendix A for the addresses for your device). The function keys can also be used to view an assigned parameter.

3.With the desired parameter displayed, press edit; the unit will display the current parameter value and prompt for a new value. Use the keypad to enter the correct value and then press ent to execute the change. Pressing esc when the device prompts for the new value will abort the process. Pressing ent if nothing has been typed also leaves the parameter unchanged.

3-6 January 2002