![](/images/new-backgrounds/1175081/175081141x1.webp)
MTEK6000 SERIES USER'S MANUAL
APPENDIX E : Certifications (CSA, UL and FCC Drawings and Statements
CONSUMER INFORMATION AND FCC REQUIREMENTS
1.The Federal Communication commission (FCC) has established rules, which permits this device to be directly connected to the telephone network. Standardized jacks are used for these connections. This equipment should not be used on party lines or coin lines.
2.If this device is malfunctioning, it may also be causing harm to the telephone network; this device should be disconnected until the source of the problem can be determined and unit repair as been made. If this is not done, the telephone company may temporarily disconnect service.
3.The telephone company may make changes in its technical operations and procedures. If such changes affect the compatibility or use of this device, the telephone company is required to give adequate notice of the changes.
4.If the telephone company requests information on what equipment is connected to its lines, inform them of:
(a)The telephone number that this unit is connected to
(b)The ringer equivalence number [0.8B]
(c)The USOC jack required [ RJ11C ]
(d)The FCC Registration Number BK5
Items (b) and (d) are indicated on the label. The ringer equivalence number (REN) is used to determine how many devices can be connected to your telephone line. In most areas, the sum of the RENs of all devices on any line should not exceed five (5.0). If too
many devices are attached, they may not ring properly.
Service Requirement
5.In the event of equipment malfunction, all repairs should be performed by our Company or an authorized agent. It is the responsibility of users requiring services to report the need for service to our Company or to one of our authorized agents.
Service can be obtained at:
Metretek, Inc.
300 North Drive,
Melbourne, Florida 32934
Telephone:
This device complies with Part 15 and Part 68 of the FCC Rules. Operation is subjected to the following two conditions:
[1]This device may not cause harmful Interference, and
[2]This device must accept any interference received, including interference that may cause undesired operations.
January 2002 |