Removal and Replacement Procedures

2.Slide the left end of the processor release bar 1 forward until it clears the clip on the processor bracket (Figure 5-22).

3.Swing the processor release bar up and to the right 2 until it rests in an upright position.

4.Lift the processor straight up 3 and remove it from the processor socket.

When installing the processor, make sure the gold triangle 4 is in the lower right corner.

Figure 5-22. Removing the Processor

Reverse the preceding procedures to install the processor.

5–28

Maintenance and Service Guide

Page 120
Image 120
Compaq N1000 manual Reverse the preceding procedures to install the processor