9.When the Light Frequency Selection dialog box appears (see Figure 1-8), click the Yes button and then click the option button that represents your power supply frequency if you use fluorescent lighting.

Otherwise, click the No button.

10.Click the OK button.

i.If you are prompted to insert the Windows 98 CD-ROM, proceed to step 10ii. Otherwise, skip to step 11.

ii.Click the OK button.

iii.In the Insert Disk dialog box, browse to the Win98 folder and then click the OK button.

iv.Click the OK button again.

Figure 1-8: The Light Frequency Selection dialog box.

11.Restart the system.

12.After the system has restarted, proceed to install the applications for WebCam Go. Remove the Windows 98 CD-ROM and insert the WebCam Go CD into the CD-ROM drive. The setup program runs automatically and a dialog box that lists the available applications appears.

13.Select the applications you want to install, except for Internet Explorer (IE) 5.0, and then click the OK button.

Note: If you want to install IE, restart the system, run D:\CTRUN\CTRUN.EXE, deselect all the other applications, and select IE.

14.Follow the instructions on the screen to complete the installation.

Depending upon the applications you choose to install, you may be asked if you want to restart your computer at the end of the installation routine. Select No whenever you are asked until all the drivers and applications have been installed. Then, restart your computer.

1-8 Installing WebCam Go