Crestron CEN-WAP-ABG-1G 802.11a/b/g Wireless Access Point
Specify MAC addresses of a maximum of 64 wireless devices whose access you
want to control by doing either of the following:
Manually enter MAC addresses one at a time:
In the MAC Address text box, enter a MAC address in hexadecimal format
(xx-xx-xx-xx-xx-xx), and then click Add. The MAC address appears at the
bottom of the MAC filter list.
Up to 64 MAC addresses can be added to the list – one address at a time.
Download a MAC filter list to the access point:
1. Prepare a text file containing a maximum of 64 MAC addresses,
and save the file in the desired location. A sample of a text file
follows.
Sample MAC Address Text File
2. In the MAC Filter List Filename text box, enter the path of the text
file or click Browse to locate the file.
3. Click Upload to upload the text file to the access point.
A message appears indicating that the procedure for firmware
upgrading takes about 1-2 minutes. The MAC addresses in the text
file appear in the MAC filter list.
NOTE: To remove a MAC address from the MAC filter list, click Delete.
Configuring Enterprise
(IEEE 802.1x/RADIUS)
Settings
NOTE: Configure Enterprise settings only if you plan to use a RADIUS server in
conjunction with the access point for authentication and only if wireless security
mode is set to any of the following: Enterprise WPA with TKIP, Enterprise
WPA with AES, Enterprise WPA2 with TKIP, or Enterprise WPA2 with AES.
To configure IEEE 802.1x/RADIUS settings, click the WIRELESS tab and then click
the ENTERPRISE subtab. The “IEEE 802.1x/RADIUS” page opens.
Operations & Installation Guide – DOC. 6695B 802.11a/b/g Wireless Access Point: CEN-WAP-ABG-1G 31