802.11a/b/g Wireless Access Point Crestron CEN-WAP-ABG-1G
Viewing the Status of
Associated Wireless Clients
To view the status of wireless clients that are associated with the access point, click
the STATUS tab and then click the WIFI CLIENTS subtab. The “Associated Wireless
Clients” page opens.
“Associated Wireless Clients” Page
NOTE: To refresh the screen, click Refresh at the bottom of the screen.
For each associated client, the Wireless Clients Status table displays the following
information:
No.: Displays the numerical order in which the client was associated with the access
point.
MAC Address: Displays the MAC address of the client.
Tx Bytes: Displays the number of bytes transmitted by the access point to the client
since its association with the access point.
Rx Bytes: Displays the number of bytes received by the access point from the client
since its association with the access point.
Data Rate: Displays the connection speed between the client and the access point in
megabits per second (Mbps).
NOTE: Because some clients measure the speed of the network differently than the
access point, the data rate shown may not match the data rate reported by your
wireless clients.
Signal Strength: Displays the strength of the radio signal in dBm, which measures
the quality of the client’s wireless connection. A value above 45 is very good. A
value of 30 is acceptable. A value below 30 may indicate connection issues.
The value changes as the distance between the client and the access point changes.
Last Activity Time (secs): Displays the time in seconds that wireless data was last
transmitted to or received from the client.
42 802.11a/b/g Wireless Access Point: CEN-WAP-ABG-1G Operations & Installation Guide – DOC. 6695B