Crestron CEN-WAP-ABG-1G 802.11a/b/g Wireless Access Point
Wall Mounting The CEN-WAP-ABG-1G mounts into a one-gang low-voltage bracket or electrical
box. The recommended depth of the electrical box is a minimum of 2.5 inches. The
maximum voltage of the access point is 48 VDC.
NOTE: To increase airflow, it is recommended that a low-voltage bracket be used
instead of an electrical box.
NOTE: For the best possible range, it is recommended that you mount the device as
high as possible and away from metal objects.
To mount the access point into a low-voltage bracket or electrical box (refer to the
illustration below):
1. Orient the access point properly, and then place the device into the bracket or
electrical box.
2. Attach the access point to the bracket or electrical box using the two #6-32 x ¾”
Phillips pan head screws included with the access point.
3. Attach the desired Decora® faceplate (not included).
CEN-WAP-ABG-1G Wall Mounting (Low-Voltage Bracket Shown)
#6-32 x ¾”
Phillips Pan Head
Screws
Rack Mounting The CEN-WAP-ABG-1G mounts horizontally into a rack and occupies 1U
(1.75 inches) of rack space.
NOTE: It is recommended that the access point be mounted into a rack only if the
connected Wi-Fi devices are to be used less than 20 feet away from the access point
and have line of sight to the access point.
NOTE: For the best possible range, it is recommended that you mount the device
into the topmost rack space.
To mount the unit, use the Middle Atlantic HBL1-722243 or equivalent rack mount
panel. For ordering information, contact Middle Atlantic Products, Inc.
(http://www.middleatlantic.com).
Operations & Installation Guide – DOC. 6695B 802.11a/b/g Wireless Access Point: CEN-WAP-ABG-1G • 9