7. Other Functions
7.4 Command Control via the Network
You can configure and control the projector via the network using
Communication Port
The following two ports are assigned for the command control.
TCP #23 (Network Control Port1 (Port: 23))
TCP #9715 (Network Control Port2 (Port: 9715))
NOTE • Command control is available only via the specified port above.
Command Control Settings (&22)
Configure the following items from a web browser when command control is used. Example: If the IP address of the projector is set to 192.168.1.10:
1)Enter “http://192.168.1.10/” into the address bar of the web browser, and select
Projector Web Control from the selection window.
2)Enter your user name and password, and then click the [OK].
3)Click the [Port Settings] on the main menu.
4)Click the [Enable] check box to open Network Control Port1 (Port: 23) to use
TCP #23. Click the [Enable] check box for the [Authentication] setting when authentication is required, otherwise clear the check box.
5)Click the [Enable] check box to open Network Control Port2 (Port: 9715) to use TCP #9715. Click the [Enable] check box for the [Authentication] setting when authentication is required, otherwise clear the check box.
6)Click the [Apply] button to save the settings.
62
