Crestron electronic MPS-250 Record Source Mix Aud. Only

Multimedia Presentation System 250 Crestron MPS-250
• Adjust the Record Volume level by turning the volume control clockwise to
raise the volume, or counterclockwise to lower the volume. When adjusting
the Record Volume level, the display will change to indicate the volume
level.
NOTE: The Record Volume can only be used if the Fixed/Variable Mode
is set to “Variable”. For more information, refer to “Set Fixed/Variable
Mode” on page 50.
Set the Record Source Mix To set the RECORD output’s source mix:
• Access the Record Output menu as described on page 49.
• Press ENTER to open the Record Source Mix controls.
Record Source Mix Controls
Record Source Mix
Aud. Only
• Press the k or j buttons until the desired setting is displayed on the LCD.
The current setting is indicated with an asterisk (*). The following settings
are available:
⇒ Aud. Only: Sends the audio signal from the selected source to the
RECORD output.
⇒ Mic. Only: Sends the microphone input signals to the RECORD
output.
⇒ Mic + Aud: Sends a mix of the audio signal from the selected source
and the microphone input signals to the RECORD output.
NOTE: While setting the Record Source Mix, the Record Volume
level can be adjusted by turning the volume control clockwise to raise
the volume, or counterclockwise to lower the volume. When adjusting
the volume, the display will change to indicate the volume level.
• Press ENTER to save changes and return to the previous screen. To cancel
without saving changes, press MENU.
Set Fixed/Variable Mode The RECORD output can be set to operate at a fixed level or a variable level. The
SPEECH and PROGRAM outputs are not affected by changes made to the
Fixed/Variable mode.
To adjust the Fixed/Variable Mode:
• Access the Record Output menu as described on page 49.
• Press the k or j buttons until “Fixed/Variable” is displayed on the LCD
and press ENTER to open the Fixed/Variable control.
50 • Multimedia Presentation System 250: MPS-250 Operations Guide – DOC. 6647A