Multimedia Presentation System 250 Crestron MPS-250
When switching sources from the keypad, the MPS-250 will route the signal to the
projector output and then route the signal to the touchpanel output.
Turn On the System To turn on the system, press any of the source buttons on the button pad. The
selected source will be routed to all of the outputs.
NOTE: Typically, signal routing information is not displayed on the front panel of
the MPS-250. However, if an output button on the MPS-250 was pressed at any
point during operation, routing information will be displayed and updated should any
changes to routing be made.
Turn Off the System To turn off the system, press the POWER button.
Adjust the Volume Level To raise the volume level, press the VOL UP button. To lower the volume, press the
VOL DOWN button. The volume buttons will only control the volume parameter
that was selected when the Volume Control Mode was specified as described on
page 46.
Mute Audio To mute the audio output, press the MUTE button. To unmute, press the MUTE
button again. The front panel of the MPS-250 will indicate the status of the mute
function.
Control from a C2N-FTB The following describes operation of the system when using the out-of-the-box
functionality and a C2N-FTB FlipTop Control Center. If a custom program has been
created, the MPS-250 may function differently.
NOTE: Buttons for the keypad are custom engraved using Crestron SystemBuilder
software. For instructions on installing the buttons on the control center, refer to the
control center’s guide.
The control center has 10 buttons as shown in the following diagram.
C2N-FTB Buttons
NOTE: Custom buttons can be created using Crestron Engraver software. For
instructions on installing the custom buttons, refer to the C2N-FTB guide.
When switching sources from the C2N-FTB, the MPS-250 will route the signal to
the projector output and then route the signal to the touchpanel output.
80 • Multimedia Presentation System 250: MPS-250 Operations Guide – DOC. 6647A