Crestron MPS-250 Multimedia Presentation System 250
Adjust Lighting To set lighting to one of two preset lighting values, press either LIGHTS PRE 1 or
LIGHTS PRE 2.
NOTE: This function will only work if a CLS-C6, infiNET switch, or infiNET
dimmer was previously identified and connected to the MPS-250. The CLS-C6 can
be identified as a Cresnet device in the MPS-250 setup screens as described on page
66. Crestron’s infiNET switches and dimmers require a C2N-MNETGW to be
identified as described on page 66 in addition to identifying the individual switch
and/or dimmer with a unique identity code (MNET ID) using Crestron Toolbox.
CLW-DIM1RF and CLW-DIMS1RF dimmers use MNET IDs 03 and 04 while
CLW-SW1RF and CLW-SWS1RF switches use MNET IDs 05 and 06. For
information on identifying infiNET switches and dimmers, refer to the Crestron
Toolbox help file.
Control from an APAD The following describes operation of the system when using the out-of-the-box
functionality and an APAD Wall Mount LCD Controller. If a custom program has
been created, the system may function differently.
The APAD has six buttons and a Nav Wheel as shown in the following diagram.
APAD Buttons
Power Button
Soft Buttons
Soft Button
Nav Wheel
When switching sources from the APAD, the MPS-250 will route the signal to all of
the outputs.
Turn On the System To turn on the system:
1. Press the soft button labeled Source to display a list of available sources.
2. Turn the Nav Wheel to highlight the desired source (BNC 1, BNC 2,
RGBHV 3, RGBHV 4, RGBHV 5, or QM IN 6).
NOTE: Typically, signal routing information is not displayed on the front
panel of the MPS-250. However, if an output button on the MPS-250 was
pressed at any point during operation, routing information will be displayed
and updated should any changes to routing be made.
Operations Guide – DOC. 6647A Multimedia Presentation System 250: MPS-250 • 77