Call Configuration
Timeout: Various constants which are used during the call setup (like maximum timeout or number of rings) can be configured in this section.
Dial Timeout: Enter the maximum time to wait for a user to dial any key after going off hook. After this timeout is reached an error tone is played to the user. Range: 5 to 120 seconds. Default: 15 seconds.
Connection Timeout: Enter the maximum time to wait to get any response from the other end. During this period a progress tone is played and after the timeout limit is reached an error tone is played to the user. Range: 5 to 180 seconds. Default: 45 seconds.
Alerting Timeout: Enter the maximum time to play a ring back tone for outgoing calls when the called party starts ringing. For incoming calls this field defines how long the phone will ring when user doesn’t answer. Range: 5 to 120 seconds. Default: 60 seconds.
Interdigit Timeout: Enter the maximum time to wait in between digits while dialing the number. After this timeout, further digits are ignored and the collected digits will be dialed out. Range: 1 to 120 seconds. Default: 5 seconds.
Interdigit Time Enter the time between digits while dialing out the received number on FXO line using DTMF tones. Range: 50 to 1000 milliseconds. Default: 300 while Dialing: milliseconds.
FXO Rings: Enter the number of rings to wait before going off hook on FXO port when the FXO port is ringing. Range: 1 to 9 rings. Default: 2.
Note: If this field is configured as 1 then caller ID detection on the FXO port won’t work.
Dial Termination: Here you can configure if any special DTMF key like * or # to use for terminating the dialed number while placing outgoing call. Note that Inter Digit timeout will be always active.
Character Termination: Select enable if you want to terminate the dialed number using a DTMF key, otherwise select Disable. Default: Enable.
If character termination is enabled then you can also terminate the feature access keys with this.
| 15 |
