D-Link DVG-2101S PPPoE, Password, Check, Service Name, Idle Time, Out, Auto, Reconnect

Setup DVG-2101S User Manual

PPPoE

Choose PPPoE (Point-to-Point Protocol over Ethernet) if your ISP uses a PPPoE connection. Your ISP will provide you with a username and password. Most DSL users will select this option.

PPPoE User Enter the PPPoE user name supplied by your ISP.

Name	Enter the PPPoE password supplied by your ISP.
PPPoE
Password	Retype the password entered in the previous field.
Check
Password	Enter the PPPoE Service Name (if supplied by your ISP).
PPPoE
Service
Name	Set the specific period of time, in minutes, to disconnect from the
Idle Time
Out	ISP when no traffic is passing through. The setting 0 minute
	means the VoIP adapter will never disconnect from the ISP.
Auto	Check this checkbox to allow the VoIP Adapter to re-establish the
Reconnect	connection if it is terminated by the ISP. However, if the
	connection is terminated under any other conditions (i.e. by Idle
	Timeout or manual disconnect), the VoIP Adapter will not re-
	establish the connection. This box is checked by default.
MTU	Enter the MTU (Maximum Transmission Unit) size. MTU is the
	largest size packet that can be sent by the device. If the network
	stack of any packet is larger than the MTU value, then the packet
	will be fragmented before the transmission. During the PPP
	negotiation, the peer of the PPP connection will indicate its MTU
	and will accept any value up to that size.
	15