Preparing for Installation

Ceiling or

Back wallcabinet bottom

Duct Cut-Out for Rear Venting

Duct Cut-Out for Top Venting

Installation Instructions

warning

•Do not install the range hood unless the electrical service provided meets the range hood specifica- tions.

•Observe all governing codes and ordinances during installation. Contact your local building department for further information.

•A qualified technician must complete the installa- tion of this built-in appliance. More than one person is required to raise the hood into place. The owner is responsible to make sure the hood is properly installed.

Blower Rotation Instructions

MODEL

SEE PAGE

EH3012, MH3012, EH3612, MH3612,

10

EH4212

 

EH4812, MH4812

11

EH3018, MH3018, EH3618, MH3618,

13

EH4218

 

EH4818, MH4818, EH5418

15

1.Start by removing the filters from the bottom of the hood. Put them in a safe location so that they will not be damaged.

2.If the hood will be installed in a top exhaust configura- tion, skip to page 16. If the hood will be installed so that air will exhaust out of the back, the blowers must be rotated into the correct position before hanging the hood. The procedure for rotating the blower depends on the hood model number. See the table at the right.

9