Installation Instructions
Rotating the Blower for Models:
EH4818, MH4818 and EH5418 (Models that are 18 inches high equipped with two blowers.
1.Place the hood assembly on a large flat surface.
2.Remove and save the screws and the two (2) duct col- lars from the top of the unit.
3.Remove and save the screws and the two (2) cover plates that cover the holes on the back of the hood.
Duct Collar
Cover Plate
8.Disconnect both wiring harness connectors from the blower motors.
9.While supporting each blower from below, remove the four (4) nuts that hold each blower in place. Remove both blowers from the hood.
10.Insert the opening of each blower motor into the holes inside the back of the hood. The connector on the motors must be toward the bottom of the hood. Attach them with four (4) nuts each.
4.Tip the hood back, so that it lays on its back with the front pointing up.
5.Remove the filters from the under side of the hood.
6.Locate the wiring harness. Cut the cable tie that takes up the slack in the cable. It is located behind the panel
on the right side, inside the hood. Also cut the two (2) cable ties that hold the wiring harness to the brace inside the hood, on the right side.
7. Remove and save all the nuts that hold the wiring har-
ness cable clamps in place. Remove and save the clamps.
Remove cable
clamps
Wiring Harness | Connector |
| |
| locations |
Remove cable ties
15