Dacor EH4812 and MH4812 (Models that are 12 inches high equipped with two blowers

Installation Instructions

13.Insert the opening on the blower motor assembly into the hole inside the back of the hood. The connector on the motor must be toward the bottom of the hood. Attach it using four (4) nuts.

17.Tip the hood back down so that the top of the hood faces up. Using existing screws, attach the cover plate removed in step 3 to the top of the hood to cover the hole.

18.Attach the duct collar removed in step 2 to the back of the unit using four (4) existing screws.

Connector

location

14.Route the wiring harness as shown. Secure the har- ness to the motor assembly with the cable clamps sup- plied with the hood in the positions shown below.

15.Attach the wiring harness to the brace inside the hood, on the right side using two (2) supplied cable ties.

16.Use a cable tie to take up any remaining slack that may exist in the wiring harness. Stow the harness behind the plate on the right side. Securing any slack will reduce additional noise due to vibration.

Cable

Clamps Wiring

Harness

Cable

Ties

Rotating the Blower for Models:

EH4812 and MH4812 (Models that are 12 inches high equipped with two blowers.

1.Place the hood assembly on a large flat surface.1.

2.Remove and save the screws and the two (2) duct col- lars from the top of the unit. See below.

3.Remove and save the screws and the two (2) cover plates that cover the holes on the back of the hood.

Duct Collar

Cover Plate

IMPORTANT: For proper
operation, route and secure	Cable tie if
the harness exactly as shown.
	necessary

11