Installation Instructions
14.Route the wiring harness as shown below. Secure the harness to the motor assemblies using the cable clamps supplied with the hood in the positions shown.
15.Attach the wiring harness to the brace inside the hood, on the right side using two (2) supplied cable ties.
16.Use a cable tie to take up any remaining slack that may exist in the wiring harness. Stow the harness behind the plate on the right side. Securing any slack will reduce additional noise due to vibration.
Rotating the Blower for Models:
EH3018, MH3018, EH3618, MH3618, EH4218 (Models that are 18 inches high equipped with a single blower)
1. | Place the hood assembly on a large flat surface. |
2. | Remove and save the four (4) screws and the duct col- |
| lar from the top of the unit. |
Cable
Clamps
Wiring
3. Remove and save the four (4) screws and the cover |
plate that covers the hole on the back of the hood. |
Harness
Cable
Ties
Duct Collar
Cover Plate
IMPORTANT: For proper |
|
operation, route and secure | Cable tie if |
the harness exactly as shown. | necessary |
17.Tip the hood back down so that the top of the hood faces up. Using existing screws, attach the cover plates removed in step 3 to the top of the hood to cover the holes.
18.Attach the duct collars removed in step 2 to the back of the unit using the existing screws.
4.Tip the hood back, so that it lays on its back with the front pointing up.
5.Remove the filters from the under side of the hood.
6.Locate the wiring harness. Cut the cable tie that takes up the slack in the cable. It is located behind the panel on the right side inside the hood. Also cut the two (2) cable ties that hold the wiring harness to the brace inside the hood, on the right side.
7.Remove and save the nut that holds the wiring harness cable clamp in place. Remove and save the clamp.
Remove
cable clamp
Wiring
Harness
Remove cable ties
13