Installation Instructions
8.Disconnect the wiring harness connector from the blower motor.
9.While supporting the blower from below, remove the four (4) nuts that hold the blower in place. Remove the blower from the hood.
11.Route the wiring harness as shown. Secure the har- ness to the motor assembly with the cable clamps sup- plied with the hood in the positions shown below.
12.Attach the wiring harness to the brace inside the hood on the right side using two (2) supplied cable ties.
13.Use a cable tie to take up any remaining slack that may exist in the wiring harness. Stow the harness behind the plate on the right side. Securing any slack will reduce additional noise due to vibration.
Cable
Clamps
Wiring
Harness
Cable
Ties
10. Insert the opening on the blower motor into the hole inside the back of the hood. The connector on the motor must be toward the bottom of the hood. Attach it using four (4) nuts.
IMPORTANT: For proper |
|
operation, route and secure | Cable tie if |
the harness exactly as shown. | necessary |
14. Tip the hood back down so that the top of the hood faces up. Using four (4) existing screws, attach the cover plate removed in step 3 to the top of the hood to cover the hole.
15. Attach the duct collar removed in step 2 to the back of the unit using the four (4) existing screws.
Connector
location
14