Dacor Preparing the AHT10 for Installation, Installing the AHT10 Transition:, Top exhaust models and 18” high models with rear exhaust:

Installation Instructions

11.Route the wiring harness as shown. Secure the har- ness to the motor assemblies using the cable clamps supplied with the hood in the positions shown below.

12.Attach the wiring harness to the brace inside the hood, on the right side using two (2) supplied cable ties.

13.Use a cable tie to take up any remaining slack that may exist in the wiring harness. Stow the harness behind the plate on the right side. Securing any slack will reduce additional noise due to vibration.

AHT10 Transition Kit Installation

On dual exhaust models, the two 8” exhausts may be merged into one 10” duct using Dacor transition kit AHT10. Install the transition before installing the hood on the wall. It connects to the hood on the top or rear, depending on the type of installation.

Preparing the AHT10 for Installation

Prepare the transition for installation by bending the bot-

Cable

Clamps

Wiring

tom edges at right angles to create a ¾” flange around the base. IMPORTANT: On 12” high hoods modified to exhaust

IMPORTANT: For proper operation, route and secure the harness exactly as shown.

Harness

Cable

Ties

Cable tie if necessary

out the rear, leave one of the long edges unbent.

	Leave this edge unmodified,
	bend up other three.
Transition Flange Prep:	Transition Flange Prep:

14.Tip the hood back down so that the top of the hood faces up. Using existing screws, attach the cover plates removed in step 3 to the top of the hood to cover the holes.

15.Attach the duct collars removed in step 2 to the back of the unit using the existing screws.

All models using top	12” high models with rear
exhaust and 18” high	exhaust
models with rear exhaust

Drill pilot holes around the edges of the mounting flange including the unmodified edge, if the transition will be mounted to the back of a 12” high hood (see above).

Installing the AHT10 Transition:

Top exhaust models and 18” high models with rear exhaust:

Center the transition over the duct collars and fasten it in place using sheet metal screws (not included). Seal the base of the transition with duct tape.

Top mounting shown

16