Installation Instructions

Hanging the Range Hood

warning

Hanging the range hood requires two people. Do not attempt to lift the hood without assistance.

1.Remove the plastic coating from the outside of the hood.

2.Remove the filter(s) to reduce weight and avoid dam- age.

3.Lift the hood up on both sides and slip the mounting slots over the tabs on the mounting brackets.

Duct Work Installation

warning

During duct installation, make sure there are no obstructions that keep the damper flaps on the top of the hood from opening.

•Install the duct work starting from the hood, working toward the outside vent. Observe the specifications on page 7.

•Fasten all joints with sheet metal screws and seal with duct tape or certified silver tape.

4.Lift the hood into its final position and mark the desired locations for the anchors or wood screws through the mounting slots on the back and top of the hood.

5.Remove the hood from the wall.

6.Drill the pilot or mounting anchor holes. If using mount- ing anchors insert them into the mounting holes.

Mounting Hole Locations

7.Reattach the hood to the temporary mounting brackets.

8.Lift the hood into its final position and fasten it in place. Insert the fasteners through the mounting slots in the back and top of the hood into the studs, mounting blocks or anchors.

18