Installation Instructions
4.Tip the hood back, so that it lays on its back with the front pointing up.
5.Remove the filters from the under side of the hood.
6.Locate the wiring harness. Cut the cable tie that takes up the slack in the cable. It is located behind the panel on the right side inside the hood. Also cut the two (2) cable ties that hold the wiring harness to the brace inside the hood, on the right side. See below.
7.Remove and save all the nuts that hold the wiring har- ness cable clamps in place. Remove and save the clamps.
Remove cable
clamps
Wiring Harness
Remove cable ties
10. Remove and discard Remove
the mounting plates and discard attached to both blow-
er motors.
11. Remove the nuts that hold the rear mounting plates in place and remove. See below.
12.Attach the mounting plates removed in step 11 (rear mounting plate) to the blower motors.
Rear Mounting 
Plate
8. Disconnect both wiring harness connectors from the blower motors.
9. While supporting each blower from below, remove the four (4) nuts that hold the blower and mounting plates in place. Remove both blowers from the hood.
13. Insert the opening of each blower motor assembly into the holes inside the back of the hood. The connector on the motors must be toward the bottom of the hood. Attach them with four (4) nuts each.
Connector
locations
12