Series | Dakota Digital 3 instruction

VACUUM FLUORESCENT DIGITAL DASHBOARD

SERIES 3

NOW WITH

SOLID STATE SENSOR TECHNOLOGY

INSTALLATION AND OPERATION MANUAL

Please read this before beginning installation or wiring.

IMPORTANT NOTE!

This system has an odometer preset option that is only

available for the first 100 miles (160km) of operation. See odometer preset section for instructions and setup information.

1	MAN 650066:D

Image 1

Dakota Digital 3 operation manual Series, NOW with Solid State Sensor Technology

Contents

NOW with Solid State Sensor Technology Series Typical Display Setups Mounting Systems with Displays Mounted to Aluminum Mounting Universal Display Systems with SubpanelsMounting Single Lens Systems Complete Systems mounted in new bezel Mounting Kits Into Original Dashes Gauge System Features Description Message Displays Control BOX Mounting Wiring the control box into the vehicle Status LED Terminal DescriptionsGround Tach PowerWarn DIM SPD SND SPD +SPD SPD OUT ADJ SND SW 1 or Speed switchADJ WTR SND OIL + WTROIL SND OIL Fuel Fuel SNDCruise Wait + Brake Right + AUX. I/O Check ENGDisplay Ribbon Cable Setting up the control box Speed sensor setup Sender Speedometer SETUP/CALIBRATION MAN 650066D Exit setup Done Tachometer SetupEngine cylinder setup T-CAL Speed Output Output Display update setup Update Volt SetupRpm warning setup Warn Tach signal setup Signal Temp sensor setup Sender Water Temp SetupTemp warning setup Warn Exit water temp setup Done OIL Pressure SetupOil pressure warning setup Warn Temp sensor test Test Exit oil pressure setup Done Fuel SetupOil pressure sensor test Test Fuel sensor setup Sender Nighttime DIM Setup Performance Menu SetupExit fuel setup Done Odometer Preset Menu BUS Interface Module SetupInformation Menu Troubleshooting Guide MAN 650066D MAN 650066D Clock Instructions For VFD systems with a clock built Troubleshooting guide Service and Repair