GAUGE SYSTEM FEATURES
Mileage readings
∙Million mile odometer
∙Two (A/B)
∙
∙High speed recall. This is reset at power up and can be manually reset.
∙High rpm recall. This is reset at power up and can be manually reset.
∙
∙¼ mile time.
∙¼ mile end speed. This is reset when the ¼ mile time restarts.
Hour meter
∙Resettable hours
∙Alternate speed can be displayed on message display. Special tachometer displays
∙On systems that do not have bar graph displays, a bar tach can be shown on the message display.
∙On systems that do not have a digital tachometer display, the rpm can be shown on the message display or the tachometer reading can be switched onto the speed display.
∙Left/Right Turn signal indicators
∙High Beam indicator
∙Check Engine indicator
∙Brake warning indicator
∙4x4 indicator
∙Wait to Start indicator
∙Cruise control indicator
∙Gear position indicator which displays full gear word with use of Dakota Digital
Special outputs
∙Shift output to activate external light
∙Selectable 2000ppm or 4000ppm speed output for cruise or ECM
Demonstration mode
∙Holding Switch 2 while turning on the key will start the system going through a preset sequence of readings. To exit the demo mode, turn the key off. You may also wire up a separate switch to power the gauges for demo mode without powering the entire vehicle.
Auxiliary gauge readings in tach message display with future expansion bus interface modules (BIM)
5 | MAN 650066:D |
