BUS INTERFACE MODULE SETUP
The bus interface modules (BIM) are a future product added to Dakota Digital instrumentation systems. They allow you to add auxiliary gauge functions, such as fuel pressure, vac/boost, trans temp, etc., right into the system without having to add additional gauges. All of the BIM readings are displayed on the tachometer message display where the tachometer and other performance readings are currently displayed. Switch 2 (SW2) is used to cycle through the various message screens.
More detailed instructions are supplied with the BIM units.
INFORMATION MENU
The information menu, “INFO” is used to display software code information should you have any troubles, this information can be useful for troubleshooting as well as the current speedometer calibration value if using the normal speed input (SPD SND).
∙Press and hold SW 1 while turning the key on.
∙Release the switch and then press and release SW1 to get to the “INFO” setup menu. You should see “SExx” on the speedometer display where xx is the software number.
∙To view the current pulse per mile (PPM) setting, press and hold the SW1 until
∙Release the switch and the odometer will show the current PPM setting/calibration value.
∙Press and release the switch to go on to the next setup menu.
ODOMETER PRESET MENU
The control box will allow you to set the odometer miles to match your current odometer reading, ONE time within the first 100 miles. Once the odometer has more than 100 miles, this menu option will no longer be displayed. Make sure you have correctly selected the units to be either MPH or km/h and calibrated your speedometer first. The odometer will be set in the selected units. Once you have preset the miles you cannot change it again without sending to the factory.
WARNING!!: This only allows setting odometer to the nearest mile. Do not use tenths! For example a mileage of 65432.1 should be set to “ 065432” using this method. If the tenths digit is used, the odometer will read 10 times too high.
∙Press and hold SW 1 while turning the key on.
∙Release the switch and then press and release SW1 to get to the
∙Press and hold the switch until
∙Press and release SW1 to increment the digit. Press and hold the switch to move to the next digit to the right.
∙Continue until the right most digit has been set. Press and hold the switch and the speed display will show “ NO”
∙If the value is incorrect press and hold the switch while “ NO” is displayed to go back and change the odometer miles or turn the key off to cancel any changes.
∙If the value is correct press and release the switch to change to speed display to “YES”.
∙Press and hold the switch while “YES” is displayed to save the current odometer reading and return to the setup menus.
26 | MAN 650066:D |
