Dakota Digital 3 Fuel Setup, Oil pressure sensor test Test, Exit oil pressure setup Done

Oil pressure sensor test (TEST)

This menu will allow you to check the voltage the control box is reading from the pressure sensor. This can be used for a diagnostic tool if you are having troubles or feel that the reading is incorrect. For the Dakota Digital SEN-03-8, 0-100 psi sensor, the voltage increases with pressure. At 0 psi, the voltage should be close to 0.5V at 100 psi the voltage should be close to 4.5V.

∙When “TEST” is displayed press and hold SW1 until you get “ - ”

∙Release SW1 and the current voltage or resistance from the pressure sensor will be displayed on the speedometer and “V OIL” is displayed on the odometer readout.

∙Press and release SW1 to scroll through the next sensor input if you wish “R FUEL”

“R TEMP” “V OIL”

∙Once complete hold SW1 until “ - ” “DONE” is displayed

∙Release the switch to go onto the next sub-menu item.

Exit oil pressure setup (DONE)

This will allow you to exit the oil pressure setup and go on to the next setup menu.

∙When “SET DONE” is displayed, press and hold SW1 until you get “ - DONE ”

∙Release the switch to go onto the next menu

FUEL SETUP

The control box can read seven common fuel level sender resistance values. If your sender is not shown in the table below, the system can be programmed to read a custom sender. The table below shows the seven pre-programmed senders and their respective empty and full resistance values.

Sender type	Menu	Empty R	Full R
GM 0-30 ohm(mid 60’s-earlier)	GM 30	0 ohms	30 ohms
GM 0-90 ohm (mid 60’s-late 90’s)	GM 90	0 ohms	90 ohms
GM 40-250 ohm (late 90’s-later)	GM 250	40 ohms	249 ohms
FORD 73-10 ohm (earlier -late 80’s)	F 10	73 ohms	10 ohms
FORD 20-150 ohm (late 80’s-later)	F 150	20 ohms	150 ohms
VDO 10-180 ohm	V 180	10 ohms	180 ohms
SW/SUN 33-240	SW 33	240 ohms	33 ohms
User programmed	CUSTOM	User settable	User settable

∙Press and hold SW 1 while turning the key on. Release the switch.

∙Press and release SW1 to get to the “FUEL” setup menu.

∙Press and hold the switch until “--FUEL” is displayed to enter the fuel setup menus, then release SW1.

∙Now you can press and release the switch to scroll through the fuel sub-menus, “SENDER”

“CUSTOM” “TEST” “DONE”. When you get to the desired sub-menu, press and hold the switch to select it.

23 MAN 650066:D