C-16
4. If you are using HP-UX 9.05, you can determine which SCSI
IDs are currently in use by looking under the H/W Path head-
ing. The listing 2.0.1 scsi is the built-in SCSI bus controller. For
devices connected to the built-in SCSI bus, such as disks, the
fourth number is the SCSI ID for that device. For example, the
listing 2.0.1.6.0 in the sample device list tells you that there is a
SCSI device (a disk) currently using ID 6 on the SCSI bus.
The information is presented in a different format if you are
using HP-UX 10.0, although you still look under the
H/W Path heading.
Single-Ended Standard System SCSI Device IDs
Before assigning a SCSI device ID to your drive, you need to check
your SCSI device IDs. To check what SCSI device IDs are available
and assign an ID to your device, follow these instructions which use
Table C–7:
1. Write in the SCSI device ID of any internal drives in Table C–7.
2. Write in the type of external drives (single-ended standard,
EISA, or fast, wide devices) currently connected to your system
under the heading “External Device Drives” and each drive’s
SCSI device ID under the heading “Device ID Number.”
3. Add your new drive to the table if it is an external device. If it is
an internal drive, continue to Step 4.
NOTICE: The C1700A Magneto-Optical Autochanger
uses three SCSI addresses, and accounts for
three of the seven devices allowed on the SCSI
bus.