1-25
SCSI ID and Device File Information for HP-UX 9.05
Default device file names for your drives are listed below. The under-
lined number in the device file name indicates the SCSI ID number:
Device Device File Name
CD-ROM drive /dev/dsk/c201d2s0
DDS-format tape drive /dev/rmt/3m
Floppy disk drive /dev/rfloppy/c201d0s0
These device file names assume the SCSI ID of your drive is set to
the factory default. If you change the factory-set value, you must
create a new device file and substitute the pathname of your device
file for the pathname above. See the System Administration Tasks
manual for information on how to create a device file.
SCSI ID and Device File Information for HP-UX 10.0 orLater
Default device file names for your drives are listed below.
Device Device File Name
CD-ROM drive /dev/[r]dsk/c#t#d#
Floppy disk drive /dev/rfloppy/c#t#d#
where
c# identifies the bus address of the SCSI interface card
t# identifies the target address of the SCSI disk
d# identifies the SCSI lun address (0, except for disk arrays)
Device file names for DDS drives at HP-UX 10.0 or later depend on
the naming conventions of the system on which you are installing:
For installation on a system permitting long file names
/dev/rmt/c#t#d#BEST AT&T style, best available density,
character entry, rw–rw–rw
/dev/rmt/c#t#d#BESTb Berkeley style, best available density
character entry, rw–rw–rw
/dev/rmt/c#t#d#BESTn AT&T style, no rewind, best available
density, character entry, rw–rw–rw
/dev/rmt/c#t#d#BESTnb Berkeley style, no rewind, best available
density, character entry, rw–rw–rw